尼龍輸送帶適用于常溫下輸送非腐蝕性的無尖刺的塊狀粒狀粉末的多種物料如煤炭焦炭 砂石 [shā shí] 水泥等散物(料)或成件物品,輸送堆積密度為6.5~2.5t/m3的各種塊狀粒狀粉狀等松散狀物料,也可用于成體物品輸送。
Nylon conveyor belt is suitable for conveying non corrosive bulk granular powder materials such as coal, coke, sand, cement and other bulk materials or finished articles at room temperature. It can also be used for conveying bulk materials with bulk density of 6.5 ~ 2.5t/m3.
不同類型規格(specifications)層數的輸送帶不宜接在共同使用,其接頭更好采用膠接法。
Different types and specifications of conveyor belts with different layers are not suitable for joint use, and the joint is best to use adhesive bonding method.
輸送膠帶的類型 結構 [jié gòu] 規格(specifications)層數應根據使用條件合理選用。
The type and structure of conveyor belt and the number of layers should be reasonably selected according to the service conditions.
輸送膠帶運行速度一般不宜大于2.5米/秒,塊度大,磨損性大的物料和使用固定(fixed)梨的 卸料裝置應盡量采用低速。
In general, the running speed of conveyor belt should not be greater than 2.5 m / s. low speed should be used as far as possible for materials with large block size and wear and unloading device using fixed pear.
運輸機的傳動滾筒直徑與輸送帶布層的關系傳動滾筒改向滾筒的配套以及對 托輥 槽角 [cáo jiǎo] 的要求應根據運輸機的設計規定,合理選取。

The relationship between the diameter of transmission drum and the distribution of conveyor belt, the matching of driving drum to drum and the requirements of idler groove angle should be selected reasonably according to the design regulations of conveyor.
給料方向應順膠帶的運行方向,為減小物料下落時對膠帶的沖擊應采溜槽,減小 物料 [wù liào] 下落距 離;膠帶受料段應縮短托輥間距和采用緩沖托輥為漏料,帶順應采用柔軟適當程度的擋料板,以免 檔料板過硬,刮破輸送帶的帶面。
The feeding direction should be along the running direction of the belt. In order to reduce the impact of the material falling on the belt, the chute should be adopted to reduce the falling distance of the material. The distance between the rollers should be shortened in the receiving section of the belt. The buffer roller should be used as the leakage material. The belt should be flexible and appropriate baffle plate should be used to prevent the baffle plate from being too hard and scraping the belt surface of the conveyor belt.
尼龍輸送帶在使用中,避免托輥(支撐輸送帶和物料重量)被物料覆蓋,造成回轉不靈,防止漏料卡于滾筒與膠帶之間,注意(attention)活動部分的潤滑, 但不得油漬污垢輸送膠帶;避免帶負荷啟動; 膠帶發生 跑偏 [pǎo piān] ,應用時采取措施(指針對問題的解決辦法)糾正; 發現膠帶局部(part)損人造棉應用時修補,以免擴大故障范圍。尼龍輸送帶,其中間夾層帆布為尼龍帆布。 尼龍(NN)輸送帶具有帶體薄強力高耐沖擊,成槽性好,層間粘合力大,屈撓性優異及使用壽命長等特點,適用于中長距離,較高載量,高速條件下輸送物料,廣泛用于礦山煤場化工冶金建筑港口等部門。
In the use of nylon conveyor belt, the idler (supporting conveyor belt and material weight) should be avoided from being covered by materials, which would cause inflexible rotation and prevent material leakage from being stuck between the drum and the belt. Attention should be paid to the lubrication of the moving part, but oil stain and dirt should not be allowed to transport the belt; the belt should not be started with load; the belt deviation [P ǎ o PI ā n] should be avoided In order to avoid expanding the fault range, measures should be taken to correct the problem during application (the solution to the problem) should be taken to correct the problem; when the part of the tape is found to be damaged, repair should be made when using cotton to avoid expanding the fault range. Nylon conveyor belt, the interlayer canvas is nylon canvas. Nylon (NN) conveyor belt has the characteristics of thin belt body, high strength, impact resistance, good grooving, strong interlayer adhesion, excellent flexibility and long service life. It is suitable for conveying materials under medium and long distance, high load and high speed. It is widely used in mining, coal yard, chemical metallurgy, construction port and other departments.
The above content is the content of today introduced by the large angle conveyor belt. For more information, please pay attention to the website: http://www.ujkdbkh.cn We will regularly update new knowledge and content for you to present