During the operation of belt conveyor, the center line of conveyor belt deviates from the center line of conveyor belt to one side. Offset is one of the common faults of belt conveyor. Long time deviation will not only cause serious wear of belt edge, but also cause belt tear, scratch and other sudden accidents. Below, conveyor belt manufacturers share conveyor belt deviation rules.

　　1. 運行松動，不緊:運行時前后滾輪中心線不平行于帶式輸送機，導致輸送帶兩側密封性不同，輸送帶會向松動一側移動。

　　1. Loose and loose operation: the center line of the front and rear rollers is not parallel to the belt conveyor during operation, which results in different sealability on both sides of the conveyor belt, and the conveyor belt will move to the loose side.

　　2. 跑高不跑低:托輥與膠帶跑向平行的水平位置不相同，但一端高，一端低，膠帶就會跑向膠帶高的一側。

　　2. Running high, not running low: the roller and tape run parallel to the horizontal position is different, but one end is high, one end is low, the tape will run to the high side of the tape.

　　3.運行后不運行前:托輥不在垂直于皮帶運行方向的橫截面上，而是一端在前，一端在后(參照皮帶運行方向)，則皮帶后端會移動。

　　3. Before running: the idler is not on the cross section perpendicular to the running direction of the belt, but on the front end and on the back end (referring to the running direction of the belt), the back end of the belt will move.

　　4. 大跑，不小跑:滾筒外表面增加t誤差，煤卡或磨損不均勻造成直徑不一致，膠帶跑到直徑較大的一側。

　　4. Run big, run small: the outer surface of the drum increases T error, coal cards or uneven wear cause diameter inconsistency, tape runs to the larger side of the diameter.

　　現在輸送帶的使用越來越普遍，很多企業都需要輸送帶來滿足項目流程。而輸送帶的使用也有很多注意的地方，以上輸送帶廠家為您總結了輸送帶偏離規律的知識，希望對廣大用戶有所幫助。

　　Now the use of conveyor belts is becoming more and more common, many enterprises need conveyor belts to meet the project process. And the use of conveyor belts also has a lot of attention, the above conveyor belt manufacturers summarized the knowledge of conveyor belt deviation rules for you, hoping to help the majority of users.