What is the loading and unloading mode of rubber conveyor belt in life? Today, there are staff members of conveyor belt factory to explain to you.

　　1. 安裝前檢查主動輪、被動輪、張力輪是否在同一平面內。一般來說，當中心距小于1 m時，兩根皮帶輪的允許偏差為2- 3mm，當中心距大于1 m時，允許偏差為3- 4mm。如果偏差過大，應在安裝和張緊前進行調整，以滿足要求。在裝卸過程中，應先松開張緊輪，或先拆下無窮大變速末端的輪盤，然后安裝或拆下皮帶。

　　1. Check whether the driving wheel, the passive wheel and the tension wheel are in the same plane before installation. Generally speaking, when the center distance is less than 1 m, the allowable deviation of two pulleys is 2 - 3 mm, and when the center distance is more than 1 m, the allowable deviation is 3 - 4 mm. If the deviation is too large, adjustments should be made before installation and tension to meet the requirements. In the process of loading and unloading, the tensioning wheel should be loosened, or the wheel disc at the end of infinite speed change should be dismantled first, then the belt should be installed or dismantled.

　　2. 當新皮帶太緊無法裝卸時，應先拆下皮帶輪，再將皮帶輪裝上或拆下后再裝上皮帶輪，不得硬拆。一般連接的v形皮帶應在裝卸后卸下。

　　2. When the new belt is too tight to be loaded and disassembled, the pulley should be removed first, then the pulley should be mounted or disassembled, and then the epithelial pulley should be installed. No hard disassembly is allowed. The V-belt of general connection should be unloaded after loading and unloading.

　　3、三角皮帶失效后應及時更換，如果一個以上三角皮帶組合使用，如果其中一個或部分有效，其他幾個根應同時更換，不能與新舊皮帶同時使用。

　　3. The triangle belt should be replaced in time after failure. If more than one triangle belt is used in combination, if one or part of the belt is valid, the other roots should be replaced at the same time, not with the old and new belt.

　　4、輸送帶張緊需要調整好。皮帶過緊，磨損嚴重，過松容易打滑

　　4. The belt tension needs to be adjusted. Too tight belt, serious wear and tear, too loose and easy to slip

　　通過對輸送帶廠家的講解，您了解了橡膠輸送帶的裝卸方法嗎?我希望我們的介紹能幫助你更好的工作

　　By explaining the manufacturer of conveyor belt, do you know the loading and unloading method of rubber conveyor belt? I hope our introduction can help you work better.