After using for a period of time, the dirt on the surface of rubber conveyor belt needs to be cleaned. On the one hand, it is to ensure the service life of the conveyor belt, on the other hand, it is to ensure the working energy consumption pool of the conveyor belt. Then how to clean the rubber conveyor belt? Jinao conveyor belt manufacturers for your detailed introduction.

　　1. 清洗橡膠輸送帶時，先關閉蒸汽閥，根據張緊裝置的位置調整壓力。

　　1. When cleaning the rubber conveyor belt, first close the steam valve and adjust the pressure according to the position of the tensioner.

　　2. 使用塑料包裝機電設備。

　　2. Use plastic packaging machinery and electrical equipment.

　　3、連接橡膠輸送帶，將洗衣機連接到220v交流。

　　3. Connect the rubber conveyor belt and connect the washing machine to 220V AC.

　　4. 把橡膠輸送帶弄濕。

　　4. Wet the rubber conveyor belt.

　　5. 將清洗液與水按1:10的比例混合，攪拌均勻。

　　5. Mix the cleaning liquid and water in a ratio of 1:10 and mix evenly.

　　6. 用槍將清洗液均勻噴在大皮帶上，注意大皮帶的加強邊，不要使用太多動量，以免傷害大皮帶，槍應掃一次，不要反復沖洗。

　　6. Spray the cleaning liquid evenly on the belt with gun. Pay attention to the strengthening edge of the belt. Don't use too much momentum to avoid damaging the belt. The gun should be swept once and not rinsed repeatedly.

　　7、用水清洗，這個時候要小心，因?yàn)橐话愕南鹉z輸送帶很難清洗，所以我們要格外注意仔細清洗，把它晾干。

　　7. Wash with water. Be careful at this time, because the rubber conveyor belt is very difficult to clean, so we should pay special attention to carefully cleaning and drying it.