輸送帶的外包裝搬運在搬運、存儲過程中起著保護作用,搬運搬運時要小心,不可野蠻搬運,以免損壞輸送帶。吊帶更好是用吊車,吊帶起吊時,先用一根強度足夠的軸桿穿過帶卷,然后用帶橫梁的鋼索吊帶平穩起吊,以避免吊帶邊緣受拉而損壞。
The outer packaging of conveyor belt plays a protective role in the process of handling and storage. Be careful when handling, and do not rough handling, so as not to damage the conveyor belt. It is better to use a crane to lift the sling. When lifting the sling, first use a shaft rod with enough strength to pass through the center of the belt coil, and then use a steel cable sling with a cross beam to lift it smoothly, so as to avoid damage caused by tension on the edge of the sling.
輸送帶卸車應自由、慢、落地,不能一邊傾斜地面,搬運帶的時候不得隨意打開包裝。盡量不要卷皮帶,如果必須卷,在卷前清理地面,防止皮帶被硬物劃傷或碰撞。皮帶卷取的方向要與皮帶卷取的方向一致,嚴禁反向卷取。也可使用叉車提升和移動,在移動時不會傷害到帶體。
The unloading of the conveyor belt should be free, slow and landing. It is not allowed to tilt the ground on one side. It is not allowed to open the package at will when carrying the belt. Try not to roll the belt. If it must be rolled, clean the ground before rolling to prevent the belt from being scratched or collided by hard objects. The direction of belt coiling shall be consistent with that of belt coiling, and reverse coiling is strictly prohibited. The forklift can also be used to lift and move, and the belt body will not be injured when moving.
搬運和存放輸送帶的注意事項,輸送帶的外包裝搬運在搬運、存儲過程中起著保護作用,搬運搬運時要小心,不可野蠻搬運,以免損壞輸送帶。

Precautions for handling and storage of conveyor belt. The outer packaging of conveyor belt plays a protective role in the process of handling and storage. Care should be taken during handling, not rough handling, so as not to damage the conveyor belt.
第二條輸送帶儲藏大型工程中,輸送帶和備用輸送帶,可以也可以存放數月甚數年,因此儲藏條件直接影響輸送帶的使用性能,良好的儲藏條件,可避免各種不利因素的影響。
In the second large-scale conveyor belt storage project, the conveyor belt and standby conveyor belt can be stored for months or even years, so the storage conditions directly affect the performance of the conveyor belt. Good storage conditions can avoid the influence of various adverse factors.
輸送帶的存放注意事項:b、輸送帶應存放在干燥、陰暗的地方,理想的存放溫度為10~20度,避免存放在5度以上、35度以下的地方。存放于戶外時,必須用防水布或類似的覆蓋材料覆蓋。并且地面墊高,避免影響輸送帶(特別是棉織物的芯帶)。
Precautions for the storage of conveyor belt: B. the conveyor belt should be stored in a dry and dark place, the ideal storage temperature is 10 ~ 20 degrees, and the place above 5 degrees and below 35 degrees should be avoided. When stored outdoors, it must be covered with waterproof cloth or similar covering material. And the ground is padded high to avoid affecting the conveyor belt (especially the core belt of cotton fabric).
傳送帶不能被太陽直接照射,貯存時應避免紫外線、X射線的照射,貯存地點不得進行電焊作業和進行各種放射性活動。能儲存或使用油,汽油,油漆,酸和化學品的地方。不能接觸或接近有臭氧和各種強氧化物質。儲存的時候好用墊板墊好,塞好塞,以防意外滾動。請勿垂直放置,以免造成扭曲。如存放時間過長,應定期翻轉,以防止內壓持續作用于同一部位。
The conveyor belt shall not be directly irradiated by the sun. Ultraviolet and X-ray irradiation shall be avoided during storage. Electric welding and various radioactive activities shall not be carried out at the storage site. A place where oil, gasoline, paint, acids and chemicals can be stored or used. Do not contact or close to ozone and various strong oxidizing substances. When storing, it is easy to use the backing plate to pad and plug, so as to prevent accidental rolling. Do not place vertically to avoid distortion. If the storage time is too long, it should be turned over regularly to prevent the internal pressure acting on the same part continuously.