大傾角保送帶運用一段時間之后，由于其表面會與貨物產生摩擦，摩擦之后會產生一定的污垢，進而影響保送帶蓋的工作效率，呈現這種情況就需求對保送帶中止清洗：
After a period of time, because of the friction between the surface and the cargo, a certain amount of dirt will be produced after the friction, which will affect the efficiency of the cover. This situation requires that the cleaning of the belt be discontinued:
1. 在清洗大傾角保送帶之前應將蒸汽閥關掉，依據張緊裝置的位置來對壓力中止調理;
1. Turn off the steam valve before cleaning the steep inclined belt, and adjust the pressure stop according to the position of the tensioner.
2. 關于機電設備，要用塑料將其包起來;
2. As for electromechanical equipment, it should be wrapped in plastic.
3. 把大傾角保送帶銜接起來，把清洗劑與220V交流電銜接起來;
3. Connect the high inclination belt and the cleaning agent with 220V AC.
4. 將大傾角保送帶浸濕，這樣做能夠使保送帶更好的吸收清洗溶液，清洗的更干凈;
4. Wet the high inclined belt, which can make the belt absorb the cleaning solution better and clean more.
5. 將水和清稀溶液10:1的比例中止混合，然后攪拌均勻;
5. Stop mixing at the ratio of 10:1 of water and dilute solution, and stir evenly.
6. 用噴槍把清洗溶液均勻的噴灑在保送帶上，要留意保送帶的加強邊，不能用力過猛，防止損傷保送帶，沖槍盡量不要一次性掃過，也不要對保送帶中止重復沖洗。
6. Spray the cleaning solution evenly on the delivery belt with a spray gun. Pay attention to the reinforcement edge of the delivery belt. Don't use too much force to prevent damage to the delivery belt. The spray gun should not sweep the delivery belt at one time or stop the repeated washing of the delivery belt.
7. 噴灑完清洗溶液以后就可以運用清水沖洗，一定要認真的沖洗干凈，然后再中止烘干。
7. After spraying the cleaning solution, you can use clean water to wash. You must wash it carefully and then stop drying.
The excellent content of this article is compiled by the big inclined conveyor belt. Our company insists on the win-win concept of honesty and cooperation to provide you with perfect service. Welcome to http://www.ujkdbkh.cn.
聯系微信
