嚴禁將同步帶強行過度折斷彎曲避免強力層損傷，失去使用價值。
It is strictly prohibited to forcibly break and bend the synchronous belt excessively, so as to avoid damage to the strong layer and loss of use value.
不得將皮帶長期處于不正常的彎曲狀態存放。
Do not store the belt in abnormal bending state for a long time.
保存在陰涼處。
Keep in a cool place.
安裝時請縮短距，放松張緊輪，不得強行將同步帶從帶輪下凸擋邊上硬拉拖磨裝入。
During installation, please shorten the center distance, loosen the tensioning wheel, and do not forcibly drag and grind the synchronous belt from the convex edge under the pulley.
帶輪的齒必須與帶的運轉方向直角。
The teeth of the pulley must be at right angles to the running direction of the belt.
主動輪與被動輪的主軸的平行度就控制在正切=1/1000左右。軸位不準，直接影響使用壽命。
The parallelism of the main shaft of the driving wheel and the driven wheel is controlled at about tangent = 1 / 1000. Inaccurate shaft position directly affects the service life.

發現主動輪上皮帶向一邊偏位，應移動一下被動輪加以調整，并調整張緊輪的壓力。
If it is found that the belt on the driving wheel deviates to one side, move the driven wheel for adjustment and adjust the pressure of the tensioning wheel.
在起動時，距改變，皮帶松馳，發生跳齒現象，應檢查帶輪機架是否松動，軸的定位有否失準。加以調整加固。
When starting, if the center distance changes, the belt looses and the teeth jump occurs, check whether the pulley frame is loose and whether the positioning of the shaft is inaccurate. To be adjusted and reinforced.
同步帶安裝時必須按不同的型號和帶寬適當?shù)募右詮埦o力。
The timing belt must be properly tensioned according to different models and bandwidths during installation.
張緊輪且一定要安裝在帶動的傳動松邊一側。
The tensioning wheel must be installed on the loose side of the drive.
以上就是今天帶給大家的知識山東同步帶專注行業多年，為用戶不斷的提供有價值的內容，更多內容請繼續關注我們：http://www.ujkdbkh.cn
The above is the knowledge brought to you today. Shandong synchronous belt has focused on the industry for many years and continuously provides users with valuable content. Please continue to pay attention to us for more content: http://www.ujkdbkh.cn