In the application of conveyor belt in the whole production process, necessary scratches and damages are inevitable. In the whole production process, repair and repair must be used. Conveyor maintenance belt is a common cold vulcanized rubber bonded and repaired in the whole production process. In the whole production process, the appearance and size of the repair belt must be appropriate according to the size of the damaged part. Under the belt conveyor belt manufacturers and everyone in-depth analysis of the characteristics of the conveyor belt repair.

　　條輸送帶修復通?？梢苑譃橥ㄓ没謴?fù)和修復的文章,文章普遍只修復層的抗壓強度和耐磨性的硫化橡膠層與強力膠半硫化橡膠硫化橡膠粘合劑層的特異性,主要用于膠帶硫化橡膠的表面損傷破壞,保持膠帶芯層織物層或鍍鋅鋼絲繩的侵蝕和破壞;在硫化橡膠層,厚修復層織物層,層織物提升有很大提高抗壓強度在文章的結構修復膠粘劑滲透破壞,劃定磨損和冷膠頭密封經常有良好的修復效果,抗壓強度必須固定匯率水平的織物結構,應用程序必須考慮所有的正常工作。

　　Generally, the repair of conveyor belt can be divided into general recovery and repair articles. In this article, only the compressive strength and wear resistance of the repair layer are generally specific to the vulcanized rubber layer and the semi vulcanized rubber adhesive layer of the strong rubber, which are mainly used for the surface damage and damage of the vulcanized rubber of the belt, to maintain the erosion and damage of the fabric layer or the galvanized steel wire rope of the belt core layer; in the vulcanized rubber layer, the thick repair layer Fabric layer, layer fabric lifting has greatly improved the compressive strength in the article's structural repair adhesive penetration damage, delimitation of wear and cold rubber head sealing often has good repair effect, the compressive strength must be fixed to the exchange rate level of fabric structure, the application program must consider all normal work.

　　輸送帶修復膠粘劑必須注意到應用程序條損害,往往是硫化橡膠損壞或常刮刮和眼淚太多,選擇相對論應該修理,不要使用一般修理修理膠帶撕裂,和表面損傷的硫化橡膠條厚修理修理帶是完全沒有必要的,但必須增加細拋光1的深度,促進建設勞動。

　　The adhesive for repairing conveyor belt must pay attention to the damage of application program strip, which is usually the damage of vulcanized rubber or too much scraping and tears. It is not necessary to use the general repair tape for tearing, and the thick repair belt for surface damage vulcanized rubber strip is completely unnecessary, but the depth of fine polishing 1 must be increased to promote construction labor.

　　條輸送帶修復回層翡翠硫化橡膠作為特異性層,這一半硫化橡膠層是修復膠粘劑表面刷,刷后冷硫化橡膠膠TX,硫化橡膠層可以用強力膠在常溫條件下迅速產生硫化橡膠反映,產生膠效果類似于熱硫化橡膠、膠粘劑與熱硫化橡膠抗壓強度可以超過同行。半硫化橡膠作為特殊層的存在，使膠布的冷膠修補更有效、更容易操作、更牢固。

　　Emerald vulcanized rubber is used as the special layer for repairing conveyor belt. The half of the vulcanized rubber layer is the surface brush of repairing adhesive. After brushing, the cold vulcanized rubber TX is used. The vulcanized rubber layer can quickly produce vulcanized rubber under normal temperature with strong rubber. The rubber effect is similar to that of hot vulcanized rubber. The compressive strength of adhesive and hot vulcanized rubber can exceed that of the same industry. Semi vulcanized rubber, as a special layer, makes the cold rubber mending of the rubber cloth more effective, easier to operate and stronger.